Datasheet

6-6
SUPERWORKSTATION 7033A-T Manual
Figure 6-4. Removing the 12-cm Exhaust Fan
6-4 Drive Bay Installation
A bezel covers the front of the chassis but does not need to be removed to
access the drives. If you wish to remove the bezel piece, push on the
three tabs on the inside left side lip of the front chassis cover. Then
slightly swing out the same (left) side of the cover - about ½ inch only.
Remove by pushing on the open side of the cover to remove it from the
chassis (do not try to swing or pull it straight out after opening the left side.
Serial ATA Drives
After unlocking the Serial ATA (SATA) drive bay door, swing it open to
access the Serial ATA drives. The drive IDs are preconfigured as 0 through
3 in order from bottom to top.
Important! Use extreme caution when working around
the SATA backplane. Do not touch the backplane with
any metal objects and make sure no ribbon cables touch
the backplane or obstruct the airflow holes in the SATA
backplane. Regardless of how many SATA hard drives are
installed, all four SATA drive carriers must remain in the
drive bays to promote proper airflow.
!