Datasheet

6-2
SUPERWORKSTATION 7033A-T Manual
6-2 Front Control Panel
The front control panel must be connected to the JF2 connector on the
motherboard to provide you with system status and alarm indications. A
ribbon cable has bundled these wires together to simplify this connection.
Connect the cable from JF2 on the motherboard (making sure the red wire
plugs into pin 1) to the appropriate comnnector on the front control panel
PCB (printed circuit board). Pull all excess cabling over to the control panel
side of the chassis. The LEDs inform you of system status - see Figure 6-
1 for details. Figure 6-2 shows the SC733 features included on the frontof
the chassis. See Chapter 5 for details on JF2.
Figure 6-1. Front Control Panel LEDs
Power
NIC
HDD
Overheat
Indicates power is being supplied to the system.
Indicates network activity on GLAN Port.
Indicates IDE hard disk/CD-ROM drive activity.
Indicates an overheat condition in either one of the
processors.