Datasheet

SUPERWORKSTATION 7033A-T Manual
1-2
1-2 Chassis Features
The SuperWorkstation 7033A-T is a high-end, mid-tower workstation chas-
sis designed with today's most state-of-the-art features. The following is a
general outline of the main features of the SC733T-450 chassis.
System Power
The 7033A-T includes a single 450W redundant cooling power supply that
features noise-suppression technology for silent operation.
Serial ATA Subsystem
The chassis was designed to support four Serial ATA hard drives, which
are also hot-swappable units. ATA/100 IDE drives are also supported.
Note: The operating system you use must have RAID support to enable the
hot-swap capability of the Serial ATA drives.
Front Control Panel
The control panel of the SuperWorkstation 7033A-T provides you with sev-
eral system monitoring and control functions. LEDs indicate system power,
hard drive activity, network activity and overheat conditions. A main power
button and a system reset button are also included on the front panel.
I/O Backplane
The SC733T-450 is an ATX form factor tower chassis. The I/O backplane
accommodates seven motherboard expansion slots, two COM ports, a par-
allel port, two USB ports, PS/2 mouse and keyboard ports and two G-bit
Ethernet ports.
Cooling System
The SC733T-450 chassis has an advanced cooling design that includes one
9-cm system cooling fan and one 12-cm exhaust fan. The 9-cm fan sits
inside an air shroud that efficiently distributes air throughout the system.
All chassis and power supply fans operate continuously, except for the
secondary power supply fan, which activates only when the primary fails
or the temperature becomes too high. The primary power supply fan, the 9-
cm system cooling fan and the 12-cm exhaust fan all have a thermal feature
that allows them to run slower and therefore quieter.