User's Guide (1.1c)

2-3
Chapter 2: Technical Specications and Installation
#5 (J1) Mini Universal Serial Bus (USB)
Connector
There is a mini USB connector (J1) located on the
AOC-SIMSO/SIMSO+ and another mini USB con-
nector is located on the AOC-USB2RJ45. Use Cable
CBL-0165L or CBL-0177L (*) to connect the two mini
USB connectors on both add-on cards for external
LAN access. Refer to Page 2-1 for details. See the
tableatrightforthepindenitions.
Refer to Note 2 on Page 2-1.
2.2.3 Connector Descriptions and Pin Denitions
Mini USB
Connector
AOC-USB2RJ45
Mini USB Pin Denitions
(J1)
Pin#Denition
1 Eth-TX_H
2 Eth-TX_L
3 Phy-100
4 Eth-RX_L
5 Eth-RX_H
6 Phy-ACT
7 Det.icated LAN-
Detected
8 3V-duall
9 Ground
#6 (JBT1) RISC CPU Reset
JBT1 is used to reset the Kira 100 Processor, NIC,
UART, USB and R.T. Instead of pins, this "jumper"
consists of contact pads to prevent the accidental
reset. Use a metal object such as a small screwdriver
to touch both pads at the same time to short the
connection. After a reset or AC power-on, the AOC-
SIMSO(+) will automatically detect if a CBL-0165L
cable is connected. If a cable is not detected, the
AOC-SIMSO(+) will transfer the "Remote Control"
Function to LAN1 on the motherboard. If a cable is
detected, the AOC-SIMSO(+) will use the dedicated
LAN on the card to manage motherboard activities
via Remote Console.
(Note: The SKT-0240L is included in the SIMSO+
shipping package.)
AOC-SIMSO(+)
CBL-0165L Cable or
CBL-0177L Cable* (See
Note 2 on Page 2-1)
The SKT-0240L (Note Below)