User's Guide (1.1)

Chapter 3: Software Application and Usage

3-1

Chapter 3

Software Application and Usage

With an independent I/O processor embedded in Raritan's Kira 100 RISC System

Chip, the AOC-SIMLC/SIMLC+ Add-On Card allows the user to access, monitor,

manage and interface with systems that are in remote locations via LAN. (See the

Note on Page 3-2.) 7KHQHFHVVDU\XWLOLWLHVIRUWKHDFFHVVDQGFRQ¿JXUDWLRQRIWKH

add-on card are included on the Supermicro bootable CDs that came with your

FDUG7KLVVHFWLRQSURYLGHVLQIRUPDWLRQRQWKHFRQ¿JXUDWLRQDQGWKHDFFHVVRIWKH

IPMI card on the network.

8VLQJWKH,30,&)*8WLOLW\WR&RQ¿JXUH,30$&$GGUHVVHVDQGRWKHU

IPMI Network Settings

1. Run the ipmicfg utility from the bootable CD that came with your shipment.

5HIHUWRWKHWDEOHEHORZWRFRQ¿JXUHWKH,30$&DGGUHVVHV

Board IPMI MAC IP Communication through

X7 Series SIMLC IPMI Card Availabl

IP/DHCP

LAN1 on MB

H8 DDR2 Memory SIMLC IPMI Card Available

IP/DHCP

LAN1 on MB

H8QM3/i-x

(Note 2 below)

SIMLC LAN1 LAN1 LAN1 on MB

)ROORZWKHLQVWUXFWLRQVJLYHQLQWKH5HDGPHW[W¿OHWRFRQ¿JXUH*DWHZD\,31HW-

PDVN,3DGGUHVVHVWRHQDEOHGLVDEOH'+&3DQGWRFRQ¿JXUHRWKHU,30,VHWWLQJV

Note17KH5HDGPHW[W¿OHLVLQFOXGHGLQWKH&'WKDWFDPHZLWK\RXUVKLSPHQW$

FRS\RIWKH5HDGPHW[W¿OHGDWHGLVDOVRLQFOXGHGEHORZ

Usage: IPMICFG Parameters (Example: IPMICFG -m 192.168.1.123)

-m Show IP and MAC

-m IP Set IP (format: ###.###.###.###)

-a MAC Set MAC (format: ##:##:##:##:##:##)

-k Show Subnet Mask

-k Mask Set Subnet Mask (format: ###.###.###.###)

-dhcp on Enable the DHCP

-dhcp off Disable the DHCP

-g Show Gateway IP

-g IP Set Gateway IP (format: ###.###.###.###)

Note 2)RUWKH+40LWKH$2&6,0/&,30,FDUGKDVWRÀDVKWKH¿UP-

ware bin from \Firmware\H8Qxx-x in the driver CD. If the AOC-SIMLC(+) IPMI card

communicates through the onboard LAN1 on the H8QM3/i-2(+), you can only use

the IPMIView Utility to access the AOC-SIMLC(+) IPMI card.