User`s manual
SC936 Chassis Manual
2-2
Power should  always  be disconnected  from the  system when  removing or  in-•
stalling main system components, such as the motherboard, memory modules,  
DVD-ROM and  oppy  drives  (not  necessary for  hot-swappable  drives).  When 
disconnecting  power,  rst  power-down  the  system  with  the  operating  system, 
and  then  unplug  the  power  cords  from  all  the  power  supply  modules  in  the 
system.
When  working  around  exposed  electrical  circuits,  another  person  who  is  fa-•
miliar  with the  power-off controls should be  nearby  to  switch off  the  power,  if 
necessary.
Use  only  one  hand when  working with  powered-on  electrical  equipment. This •
is  to  avoid  making  a  complete  circuit,  which  will  cause  electrical  shock.  Use 
extreme caution when using metal tools, which can easily damage any electrical 
components or circuit boards they come into contact with.
Do not use mats designed to decrease electrostatic discharge as protection from •
electrical shock. Instead, use rubber mats that have been specically designed 
as electrical insulators.
The  power  supply power  cord  must  include  a  grounding  plug and  must  be •
plugged into grounded electrical outlets.
Motherboard battery: CAUTION - There is a danger of explosion if the on-board •
battery  is  installed  upside  down,  which  will  reverse  its  polarities  This  battery 
must  be  replaced only with  the  same  or  an equivalent  type recommended by 
the  manufacturer.  Dispose  of  used  batteries  according  to  the  manufacturer’s 
instructions.
Please handle used batteries carefully. Do not damage the battery in any way; •
a damaged battery may release hazardous materials into the environment. Do 
not  discard  a  used  battery  in  the  garbage  or  a  public  landll.  Please  comply 
with the regulations set up by your local hazardous waste management agency 
to dispose of your used battery properly.
DVD-ROM  laser: CAUTION  -  This  server  may  have  come  equipped  with  a •
DVD-ROM drive. To prevent direct exposure to the laser beam and hazardous 
radiation  exposure,  do  not  open  the  enclosure  or  use  the  unit  in  any  uncon-
ventional way.










