User`s manual

SC936 Chassis Manual
4-6
Installing the Motherboard:
Review the documentation that came with your motherboard. Become familiar
with component placement, requirements, precautions, and cable connec-
tions.
Open the chassis cover.
As required by your motherboard, install standoffs in any areas that do not
have a permanent standoff. To do this:
A. Place a hexagonal standoff screw through the bottom the chassis.
B. Secure the screw with the hexagon nut (rounded side up).
Lay the motherboard on the chassis aligning the permanent and optional
standoffs
Secure the motherboard to the chassis using the rounded, Phillips head
screws.
Secure the CPU(s), heatsinks, and other components to the motherboard as
described in the motherboard documentation.
Connect the cables between the motherboard, backplane, chassis, front pan-
el, and power supply, as needed. Also, the fans may be temporarily removed
to allow access to the backplane ports.
1.
2.
3.
4.
5.
6.
7.
Add-on Card/Expansion Slot Setup
SC936 chassis include I/O slots for add-on cards and expansion cards. It provides
seven low-profile add-on card slots.
Installing Add-on and Expansion Cards
Disconnect the power supply, lay the chassis on a flat surface, and open the
chassis cover.
Remove the screw holding the cover in place for each low profile add-on/ex
-
pansion card slot you want to use. Keep this screw for later use.
Connect the add-on cards and/or expansion cards to the mother board.
Secure each card to the chassis using the card's L bracket and the screw
previously removed.
1.
2.
3.
4.