User`s manual

SC936 Chassis Manual
4-4
Slide the hard drive into the tray with the printed circuit board side facing
down.
Carefully align the mounting holes in both the drive tray and the hard drive.
Secure the hard drive to the tray using the screws provided.
Replace the drive tray into the chassis. Make sure to close the drive tray
handle to lock the drive tray into place.
3.
4.
5.
6.
Drive Tray
SAS or SCSI
Hard Drive
Figure 4-3: Installing the Hard Drive
Installing a Hard Drive to the Hard Drive Tray
Remove the screws securing the dummy drive to the drive tray.
Remove the dummy drive. Place the hard drive tray on a flat surface such as
a desk, table or work bench.
1.
2.
4
Figure 4-2: Removing the Dummy Drive from Tray
4-3 Installing Hard Drives
Drive Tray
Dummy Drive
1
1
2
3
4