User`s manual

5-15
Chapter 5 Chassis Setup and Maintenance
Replacing the Front Panel
SC836 chassis models include a slim DVD-ROM, a drive bay for an optional pe-
ripheral drive and front port panel. Use the instructions in this section in the unlikely
event that you must replace any of these components.
The front panel
goes into the
center slot
Figure 5-10: Installing the DVD-ROM, Optional Peripheral Drive and Front Panel
Replacing or Installing the Front Port Panel
Installing the Front Panel
1. Power-down the system and unplug the power cord.
2. Remove the chassis cover.
3. (If you are not installing a new front port panel) Remove the mini-bezel
(grate) from the drive bay The mini-bezel is the small grating that covers the
drive bay. Remove this by simply pulling it out of the bay.
(If you are installing a new front port panel) Remove the old front port
panel by depressing the release tab, then pulling the front port panel out of
the chassis.
4. Insert the new unit in the slot until the tab locks into place.
5. Connect the data and power cables to the backplane and, if necessary,
motherboard.
6. For more information, see the manual for your backplane in the appendix.