Datasheet

Chapter 5: Advanced Serverboard Setup
5-15
Wake-On-LAN
The Wake-On-LAN header is des-
ignated JWOL on the serverboard.
See the table on the right for pin
defi nitions. You must enable the LAN
Wake-Up setting in BIOS to use this
function. (You must also have a LAN
card with a Wake-On-LAN connector
and cable to use this feature.)
Universal Serial Bus (USB)
There are two Universal Serial Bus
ports located on the I/O panel and two
additional USB headers located on
the serverboard. The headers, labeled
USB2 and USB3, can be used to
provide front side USB access (cables
not included). See the tables on the
right for pin defi nitions.
Wake-On-LAN
Pin Defi nitions
(JWOL)
Pin# Defi nition
1 +5V Standby
2 Ground
3 Wake-up
LAN1/2 (Ethernet Ports)
Two gigabit Ethernet ports (desig-
nated LAN1 and LAN2) are located
beside the VGA port on the I/O back-
plane. These ports accept RJ45 type
cables.
USB Headers
Pin Defi nitions (USB2, USB3)
USB3/5
Pin # Defi nition
USB2/4
Pin # Defi nition
1 +5V 1 +5V
2 PO- 2 PO-
3 PO+ 3 PO+
4 Ground 4 Ground
5 Key 5 No connection
USB Ports Pin
Defi nitions (USB0/1)
Pin# Defi nition
1 +5V
2PO-
3PO+
4 Ground
5N/A