Installation Manual

|
21
Gas Requirements
Flexible Connections:
If the unit is to be installed with exible couplings and/or quick-
disconnect ttings, the installer must use a heavy-duty AGA
design-certied exible connector or at least1/2” (1.3 cm)
ID NPT (with suitable strainreliefs) in compliance with ANSI
Z21.41and Z21.69.
G - area for gas connection
E - area for electric connection
In Canada: CAN 1-6, 10-88 metal connectors for gas appliances
and CAN 1-6.9 M79 quick disconnect devices for use with gas
fuel.
In Massachusetts:This appliance must be installed with a 36”
(3-foot) long exible gas connector.
GAS CONVERSION WARNING!
Before carrying out this operation, disconnect the appliance
from gas and electricity. Gas conversion shall be conducted by a
factory-trained professional. Call the customer service hotline
to identify a factory-trained professional near your home. The
gas conversion procedure for this range includes 6 steps:
1. Pressure regulator
2. Surface burners
3. Main oven burner
4. Broiler burner
5. Visual checks prior to closure of oven bottom panel
6. Adjustment of minimum setting.
The conversion is not completed if all 6 steps have not been
concluded properly. Before performing the gas conversion,
locate the package containing the replacement nozzle shipped
with every range.
IMPORTANT:
Each nozzle has a number indicating its ow diameter printed
on the body. Consult the table on “Specications Technical data
“paragraph for matching nozzles to burners. Save the nozzles
removed from the range for future use.
STEP1:PRESSURE REGULATOR
The pressure regulator supplied with the appliance is a
convertible type pressure regulator for use with Natural Gas at a
nominal outlet pressure of 4” w.c. or LP gas at a nominal outlet
pressure of 11” w.c. and it is pre arranged from the factory to
operate with one of these gas/pressure as indicated in the labels
afxed on the appliance, package and Instruction booklet.
To convert the regulator for use with other liquid propane LP
gas:
1. Unscrew by hand the upper cap of
the regulator, remove the white plastic
attachment from the cap, reverse its direction
and screw it again rmly against the cap. The
white plastic attachment must be turned as
follow for NATURAL GAS and as reversed
for LP/PROPANE GAS
2. Screw by hand the metal cap in the original
position on the regulator.
LP/PROPANE GAS
NATURAL GAS