Use and Care Manual

30
Residual Heat indicator
Using your induction worktop
The cooking level of a cooking zone can be selected by turning the knob to the
according position even if no pot is present. The output of power starts automatically
as soon as a appropriate pot is put on the cooking zone. If the knob position will be
changed the display shows the according power level.
If no pot is being detected the display changes to the shown “pot missing” symbol
after a short time. This symbol will be shown until a appropriate pot is put on the
cooking zone or the maximum time of 10 minutes expired.
The same applies if the pot is removed during normal cooking.
After 10 minutes without detected pot the cooking zone switches off automatically
and can only be activated again after returning the knob into the zero position.
Pot diameter detection
The cooking level of a cooking zone can be selected by turning the knob to the
according position even if no pot is present. The output of power starts automatically
as soon as a appropriate pot is put on the cooking zone. If the knob position will be
changed the display shows the according power level.
If no pot is being detected the display changes to the shown “pot missing” symbol
after a short time. This symbol will be shown until a appropriate pot is put on the
cooking zone or the maximum time of 10 minutes expired.
The same applies if the pot is removed during normal cooking.
After 10 minutes without detected pot the cooking zone switches off automatically
and can only be activated again after returning the knob into the zero position.
Limits of cookware detection (cast iron plate is detected; pots/pans can differ):
• used in single mode - 90mm
• used in bridge mode (pot/pan on just one zone) - 110mm the other zone is not
heating up the pot/pan and shows the missing pot symbol
• used in bridge mode (pot/pan on both zones) - 220mm depends on the distance
between the two inductors
• Recommendation for the manual - plus 25mm