Installation Guide

17
461308462 07-2015
STEP 2: SURFACE BURNERS
To replace the nozzles of the surface
burners, lift up the burners and unscrew
the nozzles shipped with the range using
a 7 mm (sochet wrench).
Replace nozzles using the conversion set
supplied with the range or by a Tecno
authorized parts warehouse. Each nozzle
has a number indicating its ow diameter
printed on the body. Consult the table
on “Specications Technical data “
paragraph for matching nozzles to
burners.
STEP 3: MAIN OVEN BURNER
To replace the nozzles of the main oven
burner, start by removing the bottom
panel of the oven.
Loose the 2 screw located on the left and
right sides of the burner and the burner
from its support.
ATTENTION: pay extra attention to avoid
damage to the igniter and thermocouple.
Unscrew the nozzle located inside the gas
tting using a 10 mm or 7 mm socket
wrench. (It depends on type of injector)
For range 36”
Gas Requirements