Installation Guide

Table Of Contents

1. Unpack the new sink and check the contents of the materials supplied: sink, and cutout template.

2. Place the sink upside down in desired position on the countertop and trace completely around

the edge of the sink.

3. Use the edge of the sink as reference. Draw a proper cutout hole that larger than the sink basin

but smaller than the sink edge line.

4. Drill a pilot hole in all four corners of the inside line. Use a saber saw or jig saw to cut on the

inside line. (Note: Place a support underneath the cutout portion of the countertop to prevent it

from falling during cutting.)

5. Apply silicone sealant (not included) around the cutout on the countertop surface.

6. Carefully lower the sink into the cutout in the countertop.

7. Wipe away any excess sealant with a rag. (Note: It is recommended that keep sealant dry for

several hours before install the drain and other supplement in case of moving the sink.)

PAGE 2

Top Mount Porcelain Sink

Installation Instructions