User's Manual

ENFORCER Three- and Four-Channel RF Receiver
4 SECO-LARM U.S.A., Inc.
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT
CAUSE HARMFUL INTERFERENCE AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE
UNDESIRED OPERATION.
Notice: The changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate
the equipment.
IMPORTANT NOTE: To comply with the FCC RF exposure compliance requirements, no change to the antenna or the device is permitted. Any
change to the antenna or the device could result in the device exceeding the RF exposure requirements and void user’s authority to operate the
device.
NOTICE: The information and specifications printed in this manual are current at the time of publication. However, the SECO-LARM policy is
one of continual development and improvement. For this reason, SECO-LARM reserves the right to change specifications without notice.
SECO-LARM is also not responsible for misprints or typographical errors.
Copyright © 2015 SECO-LARM U.S.A., Inc. All rights reserved. This material may not be reproduced or copied, in whole or in part, without the
written permission of SECO-LARM.
®
U.S.A., Inc.
16842 Millikan Avenue, Irvine, CA 92606 Website: www.seco-larm.com
Tel: [phone] Fax: [phone] E-mail: [e-mail]
Model
SK
-
910R3Q
SK
-
910R3
-
4Q
SK
-
910R4Q
SK
-
910R4
-
4Q
Operating frequency
315MHz
433.92MHz
315MHz
433.92MHz
Number of channels
3
3
4
4
Memory capacity
15 transmitt
er button codes per channel
Operating voltage
11~24 VAC/VDC
Operating current
Standby
12mA@12VDC
Active
50mA@12VDC per channel
Relay contact rating
Form C 10A@24VDC or 120VAC per channel
Connectors
Screw terminals, +,
-
, with NO/NC/COM per channel
D
imensions
5.3”x3.9”x1.1” (135x100x27.5mm)
Sample Applications
:
Specifications
:
Compatible Transmitters
:
Operating frequency
315MHz
433.92MHz
Fixed Code: 68 billion codes
SK
-
919 Series Fixed Code
SK
-
939 Series Fixed Code
CODEBUMP™: 18 quintillion (1.8x10
19
) codes
SK
-
917 Series CODEBUMP
S
K
-
937 Series CODEBUMP
Positive Output
COM
NC
NO
—
+
Positi
ve Power Source
Positive Power Output
Power for receiver
Negative Output
N.C. Application with Independent Power Sources
DC Power
Source
COM
NC
NO
—
+
AC Power
Source
N.O. Application with Independent Power
Sources
COM
NC
NO
—
+
Typical N.C. Application
COM
NC
NO
—
+
E
-
941SA
-
1200
Electromagnetic Lock
Typical N.O. Application
SD
-
996C
-
NUQ
Electric Door Strike
DC Power
Source
AC Power
Source
E
-
941SA
-
1200
Electromagnetic Lock
SD
-
996C
-
NUQ
Electric Door Strike
COM
NC
NO
—
+
COM
NC
NO
—
+
Negative Power Source
Negative Power Output
Power for receiver
Order Part #
762
-
100
-
6
%
SK-910R3Q_R4Q_MuFcc_1604
P
ITSW1