User's Manual
ENFORCER Split Series Keypad with Proximity Card Reader
28 SECO-LARM U.S.A., Inc.
Programming the User Code Entry Mode:
The keypad can be programmed for auto or manual user code entry modes:
•
Auto entry mode – Pressing the key is not required after typing in a user code. In auto
entry mode, all user codes must have the same number of digits as the master code.
•
Manual entry mode – The key must be pressed after the user code to indicate the code
has been entered completely. In this case, the user codes can have a different number of
digits, from 4 to 8 digits.
SILVER
To Program:
•
For auto entry mode:
•
For manual entry mode (default):
Programming the Wrong-Code System Lock-Up:
The keypad can be programmed to lock up in order to secure the premises against unauthorized
entry if multiple wrong codes are entered or multiple wrong user cards are tapped.
When programming the wrong
-code system lock-up, use this general formula:
– Program Wrong-Code System Lock-Up
– Lock Options
Lock Options:
Choose from several different options for the wrong
-code system lock-up security level:
•
– After 10 successive false attempts using incorrect user codes or user cards, the keypad
will lock for 60 seconds (default).
•
–
After 10 successive false attempts using incorrect user codes or user cards, the duress
output will activate. The duress output can be deactivated using any user code or user card,
or via the super user code.
•
to – After 5 to 10 successive false attempts using incorrect user codes or user
cards, the keypad will lock for 15 minutes or until the super user code is used as follows:
SUPER USER CODE
•
– No system lock-up will happen.
NOTE:
The keypad’s left LE
D will remain red to show that the keypad is locked. The duress code
will still function in this mode.
NOTE: If the keypad was previously programmed for manual code entry mode and then is
reprogrammed for auto entry mode, any codes whose length exceeds the number of
digits of the master code will no longer operate the keypad. However, if the keypad is
reprogrammed for manual entry mode, the longer codes will again operate the keypad.