User's Manual

ENFORCER Split Series Keypad with Proximity Card Reader
SECO-LARM U.S.A., Inc. 27
Programming the Output #1 Auto-Disable Time (continued):
• If the programmed start time is before the end time, output #1 is auto-disabled
within a single day. If the programmed start time is after the end time, the end time
will be on the following day.
•
The start time and end time cannot be the same.
•
The auto-disable time can be temporarily paused and restarted using the super user code
(see "Programming the Super User Code" on pages 18~19).
•
During the output #1 auto-disable time, the super user code can be used to
operate output #1.
•
The keypad’s left LED will remain red during the output #1 auto-disable time.
When programming the output
#1 auto-disable time, use this general formula:
    

 – Program Output #1 Auto-Disable Time
 – Start Time
 – End Time
Start Time:
•
Start time for output #1 auto-disable time.  represents hours and  represents
minutes in the military (24-hour) time format, 00:00 to 23:59.
End Time:
•
End time for output #1 auto-disable time.  represents hours and  represents
minutes in the military (24-hour) time format, 00:00 to 23:59.
Examples
:
In these examples, assume that the sup
er user code is .
1.
In programming mode, set the output #1 auto-disable from 12:00 PM to 1:00 PM:

2.
In programming mode, set the output #1 auto-disable time from 6:30 PM to 7:30 AM the
following day:

3.
In programming mode, clear the output #1 auto-disable time:

4.
Temporarily pause and resume the output #1 auto-disable time:

5.
Activate output #1 during the auto-disable time (i.e. open the protected door):
