User's Manual

ENFORCER Split Series Keypad with Proximity Card Reader
SECO-LARM U.S.A., Inc. 25
Programming the Output Mode and Output Timing:
The relays for outputs #1, #2, and #3 can be programmed to trigger ON and OFF with a user code
or user card (toggle mode), or to trigger for a programmed length of time of up to nearly 28 hours
before automatically turning OFF. The toggle or timed outputs can be used for locking or
unlocking a door for
a variety of functions that can be controlled with the keypad.
When programming the output mode and time, use this general formula:

 – Output
 – Output Mode and Time
Outputs:
•
 – Output #1
•
 – Output #2
•
 – Output #3
Output Mode and Time:
•
 – Start/stop (toggle) mode. In this case, the output starts when a user code and/or user
card is entered, and stops when a user code and/or card is entered.
•
 to  – The output triggered by a user code and/or user card lasts 1 to
99,999 seconds (nearly 28 hours) before automatically turning off (default 5 seconds).
NOTE:
While the keypad is in momentary timed output mode, th
e output can be reset at any time
by entering the super user code.
Examples:
In these examples, assume that the super user code is
.
1.
In programming mode, set output #1 to toggle:

2.
In programming mode, set output #2 to 60 seconds:

3.
Reset output #1 timer:

4.
Reset output #2 timer:
