User's Manual

ENFORCER Split Series Keypad with Proximity Card Reader
22 SECO-LARM U.S.A., Inc.
When programming visitor codes, use this general formula:

 – Visitor ID
 – Valid Duration (hours)
 – Visitor Code
Visitor IDs:
•
 to  – 50 unique visitor IDs for visitor codes for output #1.
•
 – Delete all currently programmed visitor codes.
Valid Duration:
•
 – Set a one-time code. This code can only be used once by a visitor, after which it is
automatically deleted.
•
 to  – Set the duration the visitor code will be valid, from 1 to 99 hours.
Visitor Codes:
•
A visitor code can be 4 to 8 digits long, and must have the same length as all other codes if
the keypad is used in auto code entry mode (see "Programming the User Code Entry Mode"
on page 28).
•
All visitor codes are deleted if power is lost.
Examples:
1.
Set the visitor ID #01 code to 1268, and make it a one-time code:

2.
Set the visitor ID #02 code to 1378, and make it valid for three hours:

3.
Delete the visitor ID #02 from memory:

4.
Delete all currently programmed visitor codes:

Programming Visitor Codes for Output #1:
Visitor codes are temporary codes that expire after use or after a specified amount of time has
elapsed. While active, they operate output #1 as normal user codes.
FIRE
NOTE:
•
Visitor codes cannot be used to deactivate the duress output (see "Operating Duress Codes"
on page 24).
•
If the keypad is powered down, any programmed visitor codes will be deleted.