User's Manual

ENFORCER Split Series Keypad with Proximity Card Reader
16 SECO-LARM U.S.A., Inc.
Function
Parameters
Default functions and values
Page #
01
Master code
Default 0000, code length from 4~8 digits
17
02
Super user code
No default, must be programmed
18~19
03
Common user code for output #1
No default, must be programmed
19~20
04
Common user code for output #2
No default, must be programmed
19~20
05
Common user code for output #3
No default, must be programmed
19~20
10
User codes/cards for output #1
No default, must be programmed
20~21
20
User codes/cards for output #2
No default, must be programmed
20~21
30
User codes/cards for output #3
No default, must be programmed
20~21
40
Visitor codes for output #1
No default, must be programmed
22
41
Duress codes for output #1
No default, must be programmed
23~24
42
Duress codes for output #2
No default, must be programmed
23~24
43
Duress codes for output #3
No default, must be programmed
23~24
51
Output mode for output #1
5-Second output, momentary
25
52
Output mode for output #2
5-Second output, momentary
25
53
Output mode for output #3
5-Second output, momentary
25
55
System real-time clock
No default, must be programmed
26
56
Output #1 auto-disable time
No default, must be programmed
26~27
60
Wrong-code system lock-up
Locks keypad after 10 false code/card tries
28
70
User code entry mode
Manual entry of "#" after each code
28
71
Keypad sounds
Programming and operation beeps enabled
29
72
Output relay activation sounds
1-Second beep when output is activated
29
73
Amber LED standby flashing
Amber LED flashes on standby
30
80
Door-forced-open warning
Warning disabled
30
81
Door-propped-open warning
Warning disabled
31
90
Egress delay/warning/alarm
Egress output happens immediately
32~33
91
Door open alarm and timing
Alarm output is disabled
31
NOTE: The Direct Access to Programming (DAP) code 2828 (page 34) and the system restore
code (page 17) are fixed and cannot be changed, even via programming.
Programming Format and Default Programming Values:
In this manual, the format used for programming the keypad is as follows:
•
A 2 digit () FUNCTION identifier to tell the keypad what is being programmed.
•
A varying number of digits () to represent the parameters of this FUNCTION.
•
The () key to confirm programming of the FUNCTION.
The following is a list of different programming functions: