SDS

SDS Safety Data Sheet
Wood Flooring
Revision date: 2015-10-24 Page 4 of 4
15 REGULATORY INFORMATION …………………
Formaldehyde: Formaldehyde emission of this product is within E1 standard (EN 717-1)
Formaldehyde emission of this product is within the California Air Resources Board’s (CARB) Airborne
Toxic Control Measure (ATCM) 93120 Title 17, California Code of Regulations, and meets the CARB
Phase 2 standards.
Product does not require special protection before, during and after installation of the flooring
WEL formaldehyde – 8 hour TWA 2ppm – 2.5mg/m3/15 minute 2ppm – 2.5mg/m3
Phthalate: This product is ortho- phthalates free and comply with Californian Regulation Proposition 65.
Dust: This product is manufactured from wood. Fabrication of this product may produce wood dust. Consult local
authorities and local regulations for exposure limits. Wood dust exposure limit:
OSHA PEL:5 mg/m3 respirable dust; 15mg/m3 Total dust;
ACGIH: Hardwood dust TWA: 1 mg/m3; softwood TWA: 5 mg/m3; STEL 10 mg/m3
WEL wood dusts: 8 hour TWA 5mg/m3
PROPOSITION 65 WARNING: This product produces wood dust when cut, sanded or machined. Wood
dust is considered a carcinogen by the State of California
Asbestos: This product does not contain asbestos
U.S. Federal regulations: Not available
SARA section 313: Not available
TSCA: Not available
16 OTHER INFORMATION …………………
Partially burned dust is especially hazardous if dispersed in air. 212°F (100°C) has been suggested as the upper temperature limit for
continuous exposure of wood without risk of ignition. (Wood dust may require still a lower temperature. White pine flour as "cloud"
in air requires 0,04 j minimum energy for ignition and can produce an explosion pressure of 113 psig maximum (0,8 MPa)
OSHA - Occupational Safety and Health Administration
TSCA - Toxic Substances Control Act
ppm - parts per million
GHS – Globally Harmonized System (of classification and labeling of chemicals)
NFPA: National Fire Protection Association
USDOT – United State Department Of Transportation
DISCLAIMER …………………
To the best of our knowledge, the information contained herein accurate. However, neither the above named manufacturer nor any of
its subsidiaries assumes any liability whatsoever for accuracy or completeness of the information contained herein. Final
determination of suitability of any material is the sole responsibility of the user. All materials may present unknown hazards and
should be used with caution. Although certain hazards described herein, we cannot guarantee that these are the only hazards that exist.
END OF SDS DOCUMENT