Manual

3. Mount batteries by using battery brackets and provided hardware. The holes are pre-drilled to
fit the brackets for qty. 4 35 Ah lead acid batteries. Screws and nuts are provided. If you ordered
a different battery configuration, you’ll need to drill holes to mount them. Use foam for a snug
fit.
4. The switch will need to be disassembled to mount it to switch bracket. To do so, first remove
the screw that holds on the lever arm. The lever arm then slides off. Then remove one of the
panel nuts. Leave the other panel nut and lock washer in place slide it into the switch bracket so
that the lock washer is contacting the inside of the aluminum bracket. Slide the exterior
washer/switch label so it contacts the outside of the aluminum bracket. Then tighten together
with the panel nut. Finally, replace lever arm and secure with lever arm screw and lock washer.