Data Sheet

© SuperDroid Robots Inc
http://www.SuperDroidRobots.Com
Page
2 of 3
TTL Connector Pin-out and Color Scheme
The USB installs into your PCs USB port and installs as a COM port and will convert USB/Serial to TTL
bidirectional. Virtual COM port (VCP) drivers cause the USB device to appear as an additional COM
port available to the PC. Application software can access the USB device in the same way as it would
access a standard COM port.
This is ideal for connecting your TTL microcontroller serial communications to the PC. Today’s
computers typically do not have RS232 ports on them anymore, this solves that issue by providing you
a virtual COM port using the common USB port.
Easy to install. The drivers can also be downloaded from the FTDI site.
http://www.ftdichip.com/Drivers/VCP.htm
For first time installs it will install 2 drivers before its ready to
operate. You should only need to do this once per PC. Once installed you can remove and reinsert
the cable without having to install the drivers each time. Goto to your devise manager to determine
what COM port was used. Its typically the next available COM port on your PC.
Programmable data rates up to 2 MBaud and all handshake lines are supported.
The cable gets its power from the USB port. We also bring out a 5V supply capable of driving up to
250mA. If you pull more than 100mA the cable will be damaged and irreparable.
The wire colors are these cables are NOT the same as our RS232 Cables. The wire colors are as
follows:
Red: 5 Volt output (max 100mA)
Black: Ground
Yellow: TTL to PC
Green: TTL from PC
Orange: Ready to Send
Brown: Clear to Send
The TTL plug is a non-directional 6 pin Molex connector with 0.1” spacing. The pins can be easily re-
arranged to suit your device or you can cut the ends and put your own connector on it. (If you modify
the plug, returns will not be accepted.)
The USB end of the cable contains a compact circuit board inside the housing. The housing 0.8” wide,
0.44” thick, 1.8” long (not counting the USB plug)
All cables are tested prior to shipping.