Manual

SST2 Robot Platform
SuperDroid Robots, Inc Contact
224 Technology Park Lane [phone]
Fuquay Varina, NC 27526 [e-mail]
www.SuperDroidRobots.com
Revised: May 22, 2018 Page 4 of 6
3. Bolt the motor in using the M3X8 machine screws.
4. Mount the idler wheel assembly in the slot in the chassis. The serrated flanged nut should go up against
the outside of the chassis. Fasten in place using another serrated flanged nut on the inside of the chassis.
Make sure the wheel can spin freely but is not too sloppy. You can tighten or loosen the wheel by
adjusting the positioning of the flanged nuts.
5. Slide the aluminum hub onto the motor shaft and tighten the set screw onto the motor shaft. USE
LOCTITE to make sure you it will not back out over time.