Manual

ManualsBrandsSuperDroid Robots ManualsSDR Manufactured Tracks and WheelsSST2 Pair of Molded Spliceless Tracks and Wheel Set

SST2 Robot Platform

Assembly and Operation

This is a SST tracked robot platform and is equipped with 32mm motors, a motor

controller, and Spektrum remote control. This is a rugged robot platform. By default,

the treaded robot handles up to 5lbs of additional payload and travels 50 ft/min.

Images shown may not be an exact representation of the robot’s features listed in this document

Summary of content (6 pages)

PAGE 1
SST2 Robot Platform Assembly and Operation This is a SST tracked robot platform and is equipped with 32mm motors, a motor controller, and Spektrum remote control. This is a rugged robot platform. By default, the treaded robot handles up to 5lbs of additional payload and travels 50 ft/min.
PAGE 2
SST2 Robot Platform Contents Mechanical Assembly ................................................................................................................................................... 3 Electrical Assembly ....................................................................................................................................................... 5 General Terms.............................................................................................................................
PAGE 3
SST2 Robot Platform Mechanical Assembly 1. Assemble the idler wheels using the parts shown below. 2. Assemble the drive wheels using the hub and 4-40 machine screws as shown below. SuperDroid Robots, Inc 224 Technology Park Lane Fuquay Varina, NC 27526 www.SuperDroidRobots.com Contact (919) 557-9162 SDR@SDRobots.
PAGE 4
SST2 Robot Platform 3. Bolt the motor in using the M3X8 machine screws. 4. Mount the idler wheel assembly in the slot in the chassis. The serrated flanged nut should go up against the outside of the chassis. Fasten in place using another serrated flanged nut on the inside of the chassis. Make sure the wheel can spin freely but is not too sloppy. You can tighten or loosen the wheel by adjusting the positioning of the flanged nuts. 5.
PAGE 5
SST2 Robot Platform 6. Roll the track onto the wheels (the motors will backdrive). If the tread is not tight enough roll the tread back off, loosen up on the axle nut and slide the axle back towards the end of the slot. Do this until you have enough tension on the track.
PAGE 6
SST2 Robot Platform General Terms 1. SuperDroid Robots, Inc is not responsible for special incidental or consequential damages resulting from any warranty or under any legal theory, including, but not limited to lost profits, downtime, goodwill, damage to, or replacement equipment or property, or any cost of recovering, reprogramming, or reproducing any data stored. ANY LIABILITY SHALL BE LIMITED TO REPLACEMENT OF DEFECTIVE PARTS. SuperDroid Robots, Inc.