Assembly Manual

MLT-JR Tracked Robot Platform
SuperDroid Robots, Inc Contact
224 Technology Park Lane [phone]
Fuquay Varina, NC 27526 [e-mail]
www.SuperDroidRobots.com
Revised: May 22, 2018 Page 11 of 13
10. Mount batteries using battery brackets and hardware provided. Use foam tape on the bracket and
underneath the battery to ensure a snug fit. Mark and drill 1/8” holes that match up with the holes in the
battery bracket(s).
11. Measure a place on the chassis to mount the switch. The rear plate of the chassis is a good place for it
Make sure that it is mounted low enough that it doesn’t interfere with the lid. Drill a ½” hole.
12. Mark the holes for the motor controller and drill them out to 1/8”. Use the hardware in the provided
hardware kit to mount it.
13. Mark and drill a hole to mount the fuse block (also 1/8”).