Manual

ManualsBrandsSuperDroid Robots ManualsTreaded/Tracked RobotsMLT-42 Tracked Robot Platform

MLT-42 Kit Assembly Manual

Assembly

This is a MLT-42 tracked robot platform and is equipped with 42mm motors, a motor

controller, and Spektrum remote control. This is a rugged robot platform. By default,

the treaded robot handles up to 15lbs of additional payload and travels 200ft/min.

Images shown may not be an exact representation of the robot’s features listed in this document

Summary of content (8 pages)

PAGE 1
MLT-42 Kit Assembly Manual Assembly This is a MLT-42 tracked robot platform and is equipped with 42mm motors, a motor controller, and Spektrum remote control. This is a rugged robot platform. By default, the treaded robot handles up to 15lbs of additional payload and travels 200ft/min.
PAGE 2
MLT-42 Kit Assembly Manual Contents Mechanical Assembly ................................................................................................................................................... 2 Motor Installation..................................................................................................................................................... 2 Wheel and Track Assembly ..............................................................................................................
PAGE 3
MLT-42 Kit Assembly Manual Wheel and Track Assembly Assemble the wheels. From the picture you can see how we assembled the drive wheels first with the nuts on the inside. There is also a set screw on the side of the shaft that goes into the motor shaft. The idler wheels are assembled as shown. After this insert the bearings on each side of the wheel. SuperDroid Robots, Inc 224 Technology Park Lane Fuquay Varina, NC 27526 www.SuperDroidRobots.com Contact (919) 557-9162 SDR@SDRobots.
PAGE 4
MLT-42 Kit Assembly Manual SuperDroid Robots, Inc 224 Technology Park Lane Fuquay Varina, NC 27526 www.SuperDroidRobots.com Contact (919) 557-9162 SDR@SDRobots.
PAGE 5
MLT-42 Kit Assembly Manual Here we have the idler wheel and tension assembly put together. Look at the picture to see how the lock collar goes into the shaft assembly. Notice the plastic washer between the lock collar and the bearing also. Now mount the motor into the chassis. Notice the setscrew in the shaft of the wheel. Be sure to get it aligned with the flat spot of the motor shaft. This is very important. Use Loctite to keep it from backing out during operation.
PAGE 6
MLT-42 Kit Assembly Manual SuperDroid Robots, Inc 224 Technology Park Lane Fuquay Varina, NC 27526 www.SuperDroidRobots.com Contact (919) 557-9162 SDR@SDRobots.
PAGE 7
MLT-42 Kit Assembly Manual Electrical Assembly For electrical assembly, please follow the provided schematic on our website: Sabertooth RC Schematic When using the LiPo Batteries, the Sabertooth needs to have DIP Switch 3 set in the OFF Position as well.
PAGE 8
MLT-42 Kit Assembly Manual General Terms 1. SuperDroid Robots, Inc is not responsible for special incidental or consequential damages resulting from any warranty or under any legal theory, including, but not limited to lost profits, downtime, goodwill, damage to, or replacement equipment or property, or any cost of recovering, reprogramming, or reproducing any data stored. ANY LIABILITY SHALL BE LIMITED TO REPLACEMENT OF DEFECTIVE PARTS. SuperDroid Robots, Inc.