Assembly Manual

Mecanum Wheel Vectoring Robot Platform – IG32 DB
SuperDroid Robots, Inc Contact
224 Technology Park Lane [phone]
Fuquay Varina, NC 27526 [e-mail]
www.SuperDroidRobots.com
Revised: April 25, 2018 Page 5 of 6
7. Mark the holes for the motor controller and drill them out to 1/8”. Use the hardware in the provided
hardware kit to mount it.
8. Mark and drill a hole to mount the fuse block (also 1/8”).
Electrical Assembly
For electrical assembly please follow the provided schematic on our website:
Schematics
For additional support on wiring, soldering, and crimping, please read the following support pages:
Electric Motor Hookup Support
Electric Power Hookup Support
Soldering Tips
Crimping Wires