Manual

Mecanum Wheel Vectoring Robot - IG52 DB
SuperDroid Robots, Inc Contact
224 Technology Park Lane [phone]
Fuquay Varina, NC 27526 [e-mail]
www.SuperDroidRobots.com
Revised: April 23, 2018 Page 6 of 12
Figure 5: Sprocket with key installed
5. Measure, cut, and install the chain using the chain cutting instructions listed below.
6. Follow the instructions in the next section to wire the robot. Once finished with wiring the wheels and lid
can be installed.
Chain Measuring, Cutting, and installation
7. See the video tutorial below or follow the steps below.
Roller Chain Cutting Instructional Video
8. With the motor in the center of the slot, measure out the required length of chain and mark the two links you
need to cut.