Manual

IG42-SB4, 4WD All Terrain Robot Platform
SuperDroid Robots, Inc Contact
224 Technology Park Lane [phone]
Fuquay Varina, NC 27526 [e-mail]
www.SuperDroidRobots.com
Revised: February 8, 2019 Page 5 of 9
5. Tighten the set screws in the lock collars using Loctite. The inner lock collar should get the longer set
screw (3/8” long). Make sure the longer set screw is tightened down through the hole in the wheel shaft
and onto the center of the flat spot on the motor shaft.
6. At this point, go back and tighten the motor plate screws. Use Loctite or silicone caulk to keep the screws
from loosening.
7. Position the batteries on the chassis where you want them to be mounted. Use the battery bracket to
mark the necessary mounting holes to be drilled (typically these will be 1/8” holes). Drill the holes in the
chassis and mount the battery bracket using the included hardware and, if necessary, foam tape to ensure
a tight fit. Also included in the battery bracket hardware kit are some plastic spacers. These are to keep
the batteries from sliding underneath the battery bracket (see picture below). Position the spacer against
the end of each battery and use a 3/32 drill bit through the spacer to mark the hole in the correct place.
Drill out hole to 1/8” and mount the spacers with the included hardware.