User Manual

IG32-SB2 2WD Tube Mount Robot Platform
SuperDroid Robots, Inc Contact
224 Technology Park Lane [phone]
Fuquay Varina, NC 27526 [e-mail]
www.SuperDroidRobots.com
Revised: February 20, 2019 Page 7 of 11
7. Mount the caster brackets to the chassis plate using the existing holes and the provided ¼-20 hardware.
8. If using qty. 2 lead acid batteries, the holes are already in the chassis for mounting and screws and
standoffs will be provided with the kit. See below image for instructions. If using a different battery
configuration you will need to drill holes to mount them. Position the batteries on the chassis where you
want them to be mounted. Use the battery bracket to mark the necessary mounting holes to be drilled
(typically these will be 1/8” holes). Drill the holes in the chassis and mount the battery bracket using the
included hardware and, if necessary, foam tape to ensure a tight fit. Also included in the battery bracket
hardware kit are some plastic spacers. These are to keep the batteries from sliding underneath the
battery bracket (see picture below). Position the spacer against the end of each battery and use a 3/32
drill bit through the spacer to mark the hole in the correct place. Drill out hole to 1/8” and mount the
spacers with the included hardware.