Data Sheet

SuperDroid Robots

HD2-S Treaded Robot

Page 6 of 8

HD2 Upgrades and Add-On Options:

 Remote Release Tow Hitch. This add-on allows the robot to tow a load and remotely release it. This is useful when you need to deploy a stop

strip, etc without putting officers in harms way. The add-on will be mounted on the rear of the robot and will be fully assembled and tested.

One of the channels on the remote will control the release.

 Standard Robot Microphone (for Audio from Robot to Remote). This add-on installs a microphone on the robot with an amplifier for picking up

distant and faint noises. The microphone is a standard compact microphone that is meant for listening to large areas. The microphone will be

mounted to the robot and the audio will be transmitted back with the video transmitter via the audio channel. The audio will be broadcast real

time on the 7” Color LCD. Volume of the audio can be adjusted on the 7” monitor. The gain, etc of the amplifier is set up on the robot.

 High Gain Robot Microphone (for Audio from Robot to Remote). This add-on installs a high quality

microphone on the robot with an amplifier for picking up distant and faint noises. The microphone is a

high quality microphone that is meant for listening to large areas and reduces the amount of

electrical/white noise. The microphone will be mounted to the robot and the audio will be transmitted

back with the video transmitter via the audio channel. The audio will be broadcast real time on the 7”

Color LCD. Volume of the audio can be adjusted on the 7” monitor. The gain, etc of the microphone

and amplifier are set up on the robot. The microphone is shown on the robot picture on the front page

of this datasheet.

 PA System (for Audio from Remote to the Robot). This add-on allows the user to use a hand held radio

to broadcast to the robot through a loud speaker PA system. Using this option along with the above microphone allows 2 way communication

between the remote users and the robot. The PA speaker is shown on the robot picture on page one of this datasheet.

 Mounted LED Lights with controls. This add-on installs LED lights on the robot and includes controls to turn them on or off. The included

zoom camera has very low light viewing capabilities, but with the LED lights a very dark area can be lit up. The Lights are mounted to the

camera so they pan and tilt with the camera.

 Upgrade HD2 for removable batteries. This upgrade allows for the batteries to be removed from the top of the robot. The Standard HD2 has

hard mounted batteries inside the chassis. They are charged through a side plug on the robot while inside the robot. This upgrade allows the

batteries to be removed from the robot so they can be charged independent of the robot. Further more if a spare set of batteries are ordered,

you can remove the dead batteries and put in a new charged set in a matter of minutes. Then you can charge the dead batteries when using

the HD2 with the charged set. This upgrade adds another ~2 inches to the width of the robot making it about 22 inches wide.

 Upgrade HD2 with a spare set of batteries. Spare batteries can be purchased upon request. A removable battery option should be selected to

utilize this option.

 Upgrade HD2 with 4-Axis or 5-Axis Arm. SuperDroid Robots offers many different custom arms. Contact us for different arm configurations,

such as position control arms, clutches, more or less axis and/or degrees of freedom. This 4 axis arm includes a shoulder joint that can rotate

180 degrees. An elbow joint that can rotate ~140 degrees, a continuous turn wrist, and a gripper. Each arm axis is directly driven with gear

motors with speed control. The arm also includes the necessary controls to control the arm from our controller. When the arm is added, the

roll cage is not included and the camera is offset to one side. An optional 5

axis (~300 degree rotating base) can be added to the arm.