Notes: 1. Vin should be same voltage of relays 2. In TTL Signal should be 5v NO: Normally Open COM: Common NC: Normally Closed IN 1-7 are TTL Inputs OUT 5-7 are HIGH Current Driver Outputs(ULN2003) 5V, 12V or 24V Vin See Note 1.
Notes: 1. Vin should be same voltage of relays 2. In TTL Signal should be 5v NO: Normally Open COM: Common NC: Normally Closed IN 1-7 are TTL Inputs 5V, 12V or 24V Vin See Note 1.
Notes: 1. Vin should be same voltage of relays 2. In TTL Signal should be 5v NO: Normally Open COM: Common NC: Normally Closed IN is a TTL Input NO: Normally Open COM: Common NC: Normally Closed 5V, 12V or 24V Vin See Note 1. IN is a TTL Input 5V, 12V or 24V Vin See Note 1.
To Motor Controllers, etc 24V Out To Microcontroller, Camera, Router 12V Out Notes: 1. This can be connected to the output of the 10A relays or a high current driver (TE-010-800) can be used to control the relay with a microcontroller like an Arduino. 2. Control Battery 3.
24V Bus To Motor Controllers, etc 24V Out To Microcontroller, Camera, Router, etc 12V Out Notes: 1. This can be connected to the output of the 10A relays or a high current driver (TE-010-800) can be used to control the relay with a microcontroller like an Arduino. 2. Control Battery 3.
To Microcontroller, Camera, Router, etc 12V Out Notes: 1. This can be connected to the output of the 10A relays or a high current driver (TE-010-800) can be used to control the relay with a microcontroller like an Arduino. 2. Control Battery 3.
