Operating Instructions

Microphone operating instructions

Start-up: Short press the transmitter intermediate power key and the receiver power

key.

Shutdown: Press the transmitter intermediate power key and the receiver power key

for 3 seconds.

This product has been paired by default when it leaves the factory. It can be used

on boot. If multiple machines use serial frequency at the same time, just press the

boot button of transmitter to change frequency.

One transmitter of this product can be used in pairs with up to 10 receivers at the

same time.

In the case of replacement of transmitting or receiving equipment, it is necessary

to re-pair. The operation instructions are as follows:

1Transmitter operation:

Press the boot button for 5 seconds, when the power indicator flashes once, then

press the transmitter boot button once quickly, and when you see the power indicator

flashing, you enter the matching mode.

2Receiver operation:

After the transmitter enters the matching mode, turn on the receiver, wait 2 seconds

and press the transmitter's boot button 1 to complete the frequency matching.

At this time, you can speak to the microphone to test the voice. If the matching

is successful, the receiver will flash red light when speaking.

Exit pairing:

The frequency can be automatically locked and matched by pressing the startup key

of the transmitter.

USB cable: length 22 cm, Black

Frequency range: 560MHz-579MHz

Modulation mode: digital modulation

Signal to noise ratio: 96dB

Frequency response: 30Hz-18KHz

Antenna Type: Internal antenna

Antenna Gain:-3dBi

Distortion: <0.1%

PAGE 1
Microphone operating instructions Start-up: Short press the transmitter intermediate power key and the receiver power key. Shutdown: Press the transmitter intermediate power key and the receiver power key for 3 seconds. This product has been paired by default when it leaves the factory. It can be used on boot. If multiple machines use serial frequency at the same time, just press the boot button of transmitter to change frequency.
PAGE 2
Dynamic range: 96dB Delay: 2.5ms Frequency points: up to 48 Transmitter power: 10mW Receiver sensitivity: -96dB Use time of transmitter: 5 hours 3.7V 400mAh Receiver service time: 5 hours 3.
PAGE 3
FCC Warning Statement Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.