Operation Manual

1. INSTALLATION STEPS

1. Remove 2 screws for protecting deck;

1) Remove chassis from Slide Bracket Housing as bellows:

2) Remove 2 screws for protecting deck as right;

2. Connecting all wires

1) Making chassis wear Slide Bracket Housing again;

2) Remove control panel from chassis as follows:

A. Press OPEN button to flip down control panel .

B. Slide control panel rightwards a little, and pull it towards you .

-2-

OPEN button

PLASTIC TRIM OUT

KEY PLATE

If you want to remove chassis from Slide Bracket Housing , first remove Plastic

trim out at both sides, then insert 2 Key Plates into left and right side of chassis as

above illustration.