Operation Manual

4. Conjunct Operation
1. PWR button
To power on or off main unit.
2. VOLUME knob or VOL+ & VOL- button
To increase or decrease volume level.
3. MUTE button
To cancel or resume sound.
4. SEL button
, and
REG, PI, TA, AF, in mode
in mode and to switch
on REG, then briefly press SEL button repeatedly
5. DISP button
To display clock time, short press DISP button on remote control .
To set clock time, first long press DISP button to flash hour, and rotate VOLUME
knob or press VOL+ or VOL- button to adjust hour; then short press DISP button
again to flash minute, and rotate VOLUME knob or press VOL+ or VOL- button
to adjust minute.
6. MOD button
To switch on a signal source between RADIO, DISC, USB, CARD and AUX IN.
7. OPEN button
To flip down control panel of main unit.
8. RESET button
To resume all parameters to factory default value.
* When LCD can not display normally or sound is distorted or some controls are
disabled, use RESET button.
To switch between BAS(bass), TRE(treble), BAL(balance) FAD(fader) VOL
(volume), short press SEL button. After switching on a desired mode, rotate
VOLUME knob or press VOL+ or VOL- button to set it.
To switch between LOUD, EQ, LOC/DX( radio ), ST/
MONO( radio ), BUZZ FREQ AREA, long press SEL button
. After switching on a desired
mode, rotate VOLUME knob or press VOL+ or VOL- button to set it.
-9-