Datasheet

SuperNova Drive Datasheet
Rev 1.1 July 2012 Page 11
6. A BIOS sign-on message appears and displays a key sequence to enter the BIOS
setup. Set up the BIOS to recognize the SSD.
USING THE SSD IN A MS-DOS OS
The SSD is already partitioned and formatted by NTFS, so if you want to install MS-DOS O/S on
the SSD, it should be re-partitioned and re-formatted. After installing the SSD, it must be
installed as a disk drive under DOS. Run the DOS commands as listed below and follow the
instructions displayed for each command.
1. Run the DOS FDISK program to partition the SSD
2. Verify that the partition is active and ready for formatting
3. Run the DOS FORMAT command to high-level format the SSD
USING THE SSD IN A WINDOWS OS
No modifications need to be made to use the SSD in a Windows OS platform
USING THE SSD IN APPLE MAC OS
No modifications need to be made to use the SSD in a Windows OS platform
Just follow the steps stated in the APPLE Manual.
BOOT camp for Windows OS is verified. VMWare is also verified.
USING THE SSD IN A LINUX O/S
No modifications need to be made to use the SSD in a Linux OS platform
USING THE SSD IN OTHER O/S
No modifications need to be made to use the SSD in other OS platforms