User's Manual

How to use the “Code Learning” for RW6400

Please following step by step

1. Turn ignition (on) and turn hood (on) (waiting for 5 second for signal feed back)

2. Press the override switch 4 times (then the parking light will flashed 4 times, led steady light

on)

3. Presses the button ➀ (lock) and button ➁ (unlock) at same time, for new transmitter for

learning, siren chirps 2 times than waiting the LCD shows picture of “attain” it means this

transmitter is completed for code learning.

4. Presses the button ➀ (lock) and button ➁ (unlock) at same time, for 2

new transmitter for

learning siren chirp 3 times than waiting LCD shows picture of “attain” it means this

transmitter is completed for code learning.

5. A main unit can at most accept for 4 transmitters code learning.

How to update program option function of RW6400

Please following step by step

1. Turn ignition (on) and turn hood (on) (waiting for 5 second for signal feed back)

2. Press the override switch 5 times (then the parking light will flash 5 times, led steady light on)

For example, program the option function #12 ”door luck pulse time” when finished above 2 steps,

then keep following the below steps:

★ Press override switch 12 times (means program the option function #12) each time press the

override switch, the Parking Light will flash once, for this #12 programming totally will be

flashed 12 times by 12 times pressing the override switch. When saw the 12

flash means the

system programming mode is on the #12 option function programming status.

★ after above, press the remote “lock” button, by the mean time, the parking light will flash

once for signal, that means the programming procedure for set-up the option function #12 is

finished. Please reference the ”update program option chart” the system was set-up the

central door lock/unlock as “3 seconds pulse”, that means every lock/unlock pulse is 3

seconds, this is for match the original setting for central door lock/unlock on the MERCEDES,

BENZ.