User's Manual

5-8

A+ SERVER 1012G-MTF USER'S MANUAL

5-6 Installing Memory

Installing Memory

1. Insert each memory module vertically into its slot, paying attention to the

notch along the bottom of the module to prevent inserting the module

incorrectly (see Figure 2-1).

2. Install to slots CPU1/DIMM1A, CPU1/DIMM2A, CPU1/DIMM3A and CPU1/

DIMM4A, etc. Always install in groups of four and in the numerical order of

the DIMM slots. See support information below.

3. Gently press down on the memory module until it snaps into place.

Note: 1 GB, 2 GB, 4 GB, 8 GB, 16 GB or 32 GB size memory modules are

supported. It is highly recommended that you remove the power cord from the

system before installing or changing memory modules. Please refer to our web site

for memory that has been tested on the H8SGL-F motherboard.

Memory Support

The H8SGL-F motherboard supports single/dual/tri/quad-channel,

DDR3-1600/1333/1066 Mhz MHz registered ECC/Unbuffered ECC/non-ECC

SDRAM.

Populating four adjacent slots at a time with memory modules of the same size and

type will result in interleaved (128-bit) memory, which is faster than non-interleaved

(64-bit) memory.

Figure 5-4. DIMM Installation

To Install: Insert

module vertically and

press down until it

snaps into place.

Pay attention to the

alignment notch at

the bottom.

To Remove: Use

your thumbs to gently

push the release tabs

near both ends of the

module. This should

release it from the

slot.

Top View of DDR3 Slot

Release Tab Release Tab

Note: Notch should align with

the receptive key point on

the slot.

Notch

Front View