User's Manual
1-3
Chapter 1: Introduction
Other Features
Other onboard features that promote system health include onboard voltage
monitors, a chassis intrusion header, 3-phase switching voltage regulators, chassis
and CPU overheat sensors, Thermal Monitor 2 (TM2) support and a BIOS ash
upgrade utility.
1-3 Server Chassis Features
The following is a general outline of the main features of the SC813MTS-350CBP
chassis.
System Power
When congured as a A+ Server 1012G-MTF, the SC813 chassis includes a single
350 Watts power supply.
SATA Subsystem
For the A+ Server 1012G-MTF, the SC813 chassis was designed to support four
SATA hard drives, which are hot-swappable units.
Note: The operating system you use must have RAID support to enable the hot-
swap capability of the SATA drives (system-based RAID is not available for SATA).
Control Panel
The SC813's control panel provides important system monitoring and control
information. LEDs indicate power on, network activity, hard disk drive activity and
system overheat conditions. The control panel also includes a main power button
and a system reset button. The front of the SC813 also includes a COM port and
two USB serial ports for easy access.
Rear I/O Panel
The SC813 is a 1U rackmount chassis. Its I/O panel provides one PCI motherboard
expansion slot, one COM port (another is internal), two USB ports, a parallel (printer)
port, PS/2 mouse and keyboard ports, a VGA port and two 1-Gb Ethernet ports.