User's Manual

ManualsBrandsSUPER MICRO Computer ManualsSawSUPER MICRO Computer SBI-7426T-S3 Blade Module SBI-7426T-S3

SBI-7426T-S3 Blade Module User’s Manual

6-12

Table 6-9. AHCI Configuration Sub-menu

Menu Option Description

AHCI BIOS Support

This option enables AHCI BIOS support on your system. Options include

Enabled and D

ISABLED.

AHCI CD/DVD Boot

Time Out

This sets the timeout time in seconds for AHCI CD/DVD boot drives. Some SATA

CD/DVD drives in AHCI mode need to wait longer than others. Options include 0

(sec), 5, 10, 15, 20, 25, 30 and 35.

AHCI Port0~Port5

While entering setup, BIOS auto detects the presence of IDE devices. This

setting displays the status of auto detection of IDE devices.

SATA Port0 ~

Port5

For this setting, select the type of device connected to the system. Select Auto

to allow the AMI BIOS to automatically detect a hard disk drive in your system.

Options include Auto and N

OT INSTALLED.

S.M.A.R.T.

Self-Monitoring Analysis and Reporting Technology (SMART) can help predict

impending drive failures. Select D

ISABLED to prevent the AMI BIOS from using

S.M.A.R.T in your system. Selecting Enabled allows the AMI BIOS to use

S.M.A.R.T to support the hard disk drive. Option include D

ISABLED and Enabled.

Table 6-10. Event Log Configuration Sub-menu

Menu Option Description

View Event Log Selecting this option allows you to view all unread events on the Event Log.

Mark All Events as

Read

This option makrs all events as read. Options ae OK and Cancel when selected.

Clear Event Log

This option clears the Event Log memory of all messages. Options are OK and

Cancel.

Table 6-11. IPMI Configuration Sub-menu

Menu Option Description

Status of BMC

The Baseboard Management Controller (BMC) manages the interface between

the system management software and platform hardware. This non-configurable

informational feature shows the status code of the BMC micro controller.

View BMC System

Event Log

This feature displays the BMC System Event Log (SEL). This log shows the total

number of entries of BMC system events. To view an event, select an entry

number and press <E

NTER> to display the information as shown in the screen.

This screen contains the following information:

• Total Number of Entries

• SEL Entry Number

• SEL Record ID

• SEL Record Type

• Timestamp, Generator ID

• Event Message Format User

• Event Sensor Type

• Event Sensor Number

• Event Dir Type

• Event Data