User's Manual

SBI-7426T-S3 Blade Module User’s Manual
6-8
RAID ID Support
This setting allows you to select either the Intel or ADAPTEC RAID Configuration
Utility to be used for configuring your RAID setup. This setting is only available
when RAID is selected for SATA#1 Configuration.
Hot Plug
This setting allows you to enable the Hot Plug feature when using RAID for your
SATA devices when RAID is selected for your SATA#1 Configuration. Options
include E
NABLED or Disabled.
SATA#2
Configuration
Selecting Enhanced sets SATA#2 to native SATA mode. The options are
D
ISABLED and Enhanced.
Hard Disk Write
Protect
This setting Enables/Disables device write protection and is effective only if the
device is accessed through BIOS. The default is Enabled.
IDE Detect Tie Out
(Sec)
This setting allows you to select the time out value for detecting ATA?ATAPI
devices. Press + or - on your keyboard to change this value. The default is 35.
ATA(PI) 80Pin Cable
Detection
This setting allows you to select the mechanism for detecting 80P in ATA(PI)
cable. The default is Host & Device.
Table 6-5. PCIPnP Configuration Sub-menu
Menu Option Description
Clear NVRAM
This setting allows you to clear NVRAM during a system boot. The options are
No and Y
ES.
Plug & Play O/S
Selecting YES allows the OS to configure Plug & Play devices. Select No to allow
the AMI BIOS to configure all devices in your system.
NOTE: This is not required for system boot (select No) if your system has an OS
that supports Plug & Play.
PCI Latency Timer
This sets the latency timer of each PCI device installed on a PCI bus. For
example, select 64 to set the PCI latency to 64 PCI clock cycles. The options are
32, 64, 96, 128, 160, 192, 224 an 248.
Allocate IRQ to PCI
VGA
Select Yes to assign IRQ to the PCI VGA card if the card requests IRQ.
Selecting N
O does not assign IRQ to the PCI VGA card even if the card requests
an IRQ.
Palette Snooping
When E
NABLED, this informs PCI devices that an ISA graphics device is installed
in the system so the card will function correctly. The default is Disabled.
PCI IDE BusMaster
When enabled, the BIOS uses PCI bus mastering for reading/writing to IDE
devices. The options are D
ISABLED and Enabled.
Offboard PCI/ISA IDE
Card
Some PCI IDE cards may require this setting to be set to the PCI slot number
that is holding the card. The default Auto setting works for most PCI IDE cards.
IRQ3 ~ IRQ11
When each of these settings is set to Available, the specified IRQ is available to
be used by PCI/PnP devices. If set to R
ESERVED, the IRQ is reserved for use by
lagacy ISA devices.
Table 6-4. IDE Configuration Menu (Continued)
Menu Option Description