User's Manual

SBI-7226T-T2 Blade Module User’s Manual
6-4
IDE Configuration
The menu options in the IDE ConfiguraTION submenu and their descriptions are shown
in Table 6-2
C1 Auto Demotion
When this setting is enabled, the CPU will conditionally demote C3/C6/C7
requests to C1 based on uncore auto-demote information. Settings are Enabled
and Disabled.
C3 Auto Demotion
When this setting is enabled, the CPU will conditionally demote C6/C7 requests
to C3 based on uncore auto-demote information. Settings are Enabled and
Disabled.
Spread Spectrum
Mode
Use this setting to Enable or Disable Spread Spectrum Mode.
Table 6-2. IDE Configuration Submenu
Menu Option Description
SATA#1
Configuration
This setting allows you to set your SATA#1 Configuration as either Enhanced,
D
ISABLED or COMPATIBLE.
Configure SATA#1 as Use this setting to configure SATA#1. Options include IDE, RAID or AHCI.
Max Ports on SATA#1
Use this setting to specify the maximum ports on SATA#1. Options include
4-ports and 6-ports.
RAID ID Support
If you have selected the RAID setting above, then you may use this setting to
specify the RAID ID support used. Options include Intel or A
DAPTEC.
Hot Plug
If you have selected the RAID setting above, then you may use this setting to
enable or disable Hot Plugging. Settings are Enabled and Disabled.
Hard Disk Write
Protect
Use this setting to Enable or Disable device write protection. This will be
effective only if device is accessed through the BIOS.
IDE Detect Time Out
(Sec)
This setting allows you to select the time out value for detecting ATA/ATAPI
devices. Options are 5-second increments between 5 and 35 seconds. Default is
35.
ATA(PI) 80-Pin Cable
Detection
This setting allows you to select the mechanism for detecting an 80-pin ATA(PI)
cable. Options include Host, Device or Host & Device.
Table 6-1. CPU Configuration Submenu (Continued)
Menu Option Description