User's Manual

SBI-7226T-T2 Blade Module User’s Manual
1-2
1-3 Blade Module Features
Table 1-1 lists the main features of the SBI-7226T-T2 blade module. See the proceeding
section for components typically included in a blade system and other optional
components. Specific details on the SBI-7226T-T2 blade module is found in Chapter 4:
"Blade Module Features" on page 4-1.
Processors
The SBI-7226T-T2 blade module supports up to two 1366-pin Intel Xeon 5500 series
processors in each node for a total of four.
Refer to the Supermicro web site for a complete listing of supported processors (http://
www.supermicro.com/products/superblade). Please note that you will need to check the
detailed specifications of a particular blade module for a list of the CPUs it supports.
Details on installation of the processor into the SBI-7226T-T2 blade module are found in
Chapter 3: "Setup and Installation" on page 3-1.
Memory
The SBI-7226T-T2 blade module has eight 240-pin DIMM sockets in each node that can
support up to 16 GB of ECC Unbuffered DDR3-1333/1066/800 SDRAM or 64 GB of
ECC Registered DDR3-1333/1066/800 SDRAM DIMMs. Both interleaved and
non-interleaved memory are supported, so you may populate any number of DIMM
slots.
Table 1-1. SBI-7226T-T2 Blade Specification Features
Mainboard
B8DTT (proprietary form factor)
Chassis Dimensions (HxWxD): 11.32” x 1.67” x 20.5”
Processors
Supports two 1366-pin LGA Socket processors in each node for up to four
Intel
®
64-bit quad-core Xeon
®
series processors. Please refer to our web
site for a complete listing of supported processors.
FSB Speed QPI speed | Up to 6.4 GT/s
Chipset Intel 5500/IOH-24D Tylersburg + ICH10R
Graphics Controller Onboard Matrox G200eW Graphics chip with 16MB of SDRAM
BIOS 32 Mb AMI
®
SPI Flash EPROM BIOS
Memory Capacity
Eight 240-pin DIMM sockets per node supporting up to 64 GB of ECC
Registered DDR3-1333/1066/800 SDRAM DIMMs or 16 GB of ECC
Unbuffered DDR3-1333/1066/800 SDRAM DIMMs in two 3-DIMM and two
1-DIMM memory banks for each node.
SATA Controller
SATA Controller ICH10R on-chip controller for four Serial ATA drives, two
for each node
Hard Drive Bays Four (4) hot-swap drive bays for 2.5" SATA disk drives