SDS

Page 7 of 14
Safety Data Sheet
according to (EU) 2015 / 830 and OSHA GHS
Revision: September 12, 2016
Trade name: Super Lube® Silicone Aerosol
(Contd. of page 6)
40.1.3
TLV (USA) Short-term value: 54.000 mg/m³, 30.000 ppm
Long-term value: 9000 mg/m³, 5000 ppm
EL (Canada) Short-term value: 15000 ppm
Long-term value: 5000 ppm
EV (Canada) Short-term value: 54.000 mg/m³, 30.000 ppm
Long-term value: 9.000 mg/m³, 5.000 ppm
LMPE (Mexico) Short-term value: 30000 ppm
Long-term value: 5000 ppm
·
Ingredients with biological limit values:
67-64-1 acetone
BEI (USA) 50 mg/L
Medium: urine
Time: end of shift
Parameter: Acetone (nonspecific)
·
Additional information:
The lists that were valid during the creation were used as basis.
·
Exposure controls
·
Personal protective equipment:
·
General protective and hygienic measures:
The usual precautionary measures for handling chemicals should be followed.
Immediately remove all soiled and contaminated clothing.
Wash hands before breaks and at the end of work.
Do not inhale gases / fumes / aerosols.
Avoid contact with the eyes and skin.
·
Engineering controls:
No further relevant information available.
·
Breathing equipment:
Wear appropriate NIOSH respirator when ventilation is inadequate and occupational exposure limits are
exceeded.
Use suitable respiratory protective device in case of insufficient ventilation.
·
Protection of hands:
Protective gloves
The glove material has to be impermeable and resistant to the product/ the substance/ the preparation.
Selection of the glove material on consideration of the penetration times, rates of diffusion and the
degradation
·
Material of gloves
The selection of the suitable gloves does not only depend on the material, but also on further marks of
quality and varies from manufacturer to manufacturer. As the product is a preparation of several
substances, the resistance of the glove material can not be calculated in advance and has therefore to be
checked prior to the application.
·
Penetration time of glove material
The exact break through time has to be found out by the manufacturer of the protective gloves and has to
be observed.
(Contd. on page 8)