MSDS









PRODUCT NAME:

SUPER LUBE MULTIPURPOSE SILICONE AEROSOL

Part Number: 91110

SECTION I - MANUFACTURER IDENTIFICATION

MANUFACTURER'S NAME: SYNCO CHEMICAL CORPORATION

ADDRESS: 24 DaVINCI DRIVE, BOHEMIA, NEW YORK 11716

EMERGENCY PHONE NUMBER: 800-424-9300 INFORMATION PHONE: 631-567-5300

DATE EFFECTIVE: 01-01-2003

DATE REVISED: 01-04-2010

SECTION II - INGREDIENTS/SARA III INFORMATION

COMPONENTS CAS # OSHA PEL WGT.%

Pure Silicone Oil 63148-62-9 5- 15%

HEPTANE 142-82-5 500 PPM <49%

HYDRO TREATED LIGHT 64742-47-8 5.0mg/m

35- 40%

PETROLEUM DISTILLATE

CARBON DIOXIDE 124-38-9 10000 PPM 3%

SECTION III - PHYSICAL/CHEMICAL CHARACTERISTICS

BOILING POINT Not Applicable

SPECIFIC GRAVITY: (25C) 0.8660

VAPOR DENSITY Heavier than Air

VAPOR PRESSURE 80-90 psig @ 70°F

EVAPORATION RATE Slower than Ether

SOLUBILITY IN WATER Nil

APPEARANCE AND COLOR Aerosol Product

NFPA RATING Level 3

VOC (%) < 50

WATER CONTENT (%) None det. <0.01

PAGE 1
PRODUCT NAME: SUPER LUBE MULTIPURPOSE SILICONE AEROSOL Part Number: 91110 SECTION I - MANUFACTURER IDENTIFICATION MANUFACTURER'S NAME: ADDRESS: EMERGENCY PHONE NUMBER: DATE EFFECTIVE: DATE REVISED: SYNCO CHEMICAL CORPORATION 24 DaVINCI DRIVE, BOHEMIA, NEW YORK 11716 800-424-9300 INFORMATION PHONE: 631-567-5300 01-01-2003 01-04-2010 SECTION II - INGREDIENTS/SARA III INFORMATION COMPONENTS CAS # OSHA PEL Pure Silicone Oil 63148-62-9 HEPTANE 142-82-5 500 PPM HYDRO TREATED LIGHT PETROLEUM DISTILLATE
PAGE 2
SECTION IV - FIRE AND EXPLOSION HAZARD DATA FLASH POINT - 20°F FLAMMABLE LIMITS IN AIR BY VOLUME - LOWER: N/D METHOD USED: Pensky Martens Closed Cup UPPER: N/D EXTINGUISHING MEDIA: FOAM, ALCOHOL FOAM, CO2, DRY CHEMICAL, WATER FOG SPECIAL FIREFIGHTING PROCEDURES: Water spray may be ineffective. Water may be used to cool containers to prevent pressure build-up and explosion when exposed to extreme heat. If water is used, fog nozzles preferred. Wear goggles and self-contained breathing apparatus.
PAGE 3
SECTION VII - PRECAUTIONS FOR SAFE HANDLING AND USE STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED: AVOID BREATHING VAPORS. Ventilate areas. Remove all sources of ignition. Clean up area with absorbent material and place in closed containers for disposal. WASTE DISPOSAL METHOD: Dispose of in accordance with Local, State and Federal Regulations. Before attempting clean up, refer to other sections of the MSDS for hazard caution information.