MSDS
9420 Santa Anita Avenue
Rancho Cucamonga, CA 91730
(909) 987-0550 ٠ Corp. Office: (800) 538-3091
Fax: (909) 987-0490٠ www.pacertechnology.com
Page 1 of 3
FOR CHEMICAL EMERGENCY ONLY:
1. PRODUCT
IDENTIFICATION:
2. COMPOSITION/INGREDIENTS:
3. HAZARDS IDENTIFICATION: Emergency Overview
HMIS
NFPA
Green paste with low odor.
May be irritating to eyes & skin with direct contact. May be a skin sensitizer.
Contact with product at elevated temperatures may cause thermal burns. Pre-
existing skin & eye disorders may be aggravated. May be absorbed through
the skin in toxic amounts. KEEP OUT OF REACH OF CHILDREN.
Health
Flammability
Reactivity
Physical Hazard
2
1
0
2
1
0
Toxicity
Low order of oral toxicity noted. Unlikely to be an inhalation hazard due to low volatility.
Possible skin sensitizer. May be absorbed through the skin in toxic amounts.
Primary routes of
entry
Inhalation Skin Eyes Ingestion
X X
Signs/Symptoms
of Exposure
Inhalation
Slight irritation with poor ventilation.
Skin
Irritating to skin. May cause allergic skin reaction with prolonged contact.
Eyes
Weeping, redness.
Ingestion
Low order of oral toxicity noted.
4. FIRST AID MEASURES:
Inhalation
Remove to fresh air and provide oxygen if breathing is difficult. Get medical attention.
Skin
Remove contaminated clothing and wash skin with soap & water. Get medical attention if symptoms
persist (contaminated leather articles i.e. shoes should be disposed of as contaminated waste).
NOTE: hot product burns require immediate medical attention.
Eyes
Flush eyes with large amounts of water for 15 minutes while holding eyes open. Get medical
attention immediately.
Ingestion
Do not induce vomiting. In general, no treatment unless a large amount is ingested, however, get
medical advice. NOTE TO PHYSICIAN: Emesis induction is normally not necessary in high viscosity,
low volatility products, e.g. neat epoxy resins.
5. FIRE FIGHTING MEASURES: FLASH POINT: >200
0
F/>93
0
C LEL: NE UEL: NE
Extinguishing
Media
Water fog, foam, dry chemical or carbon dioxide.
Special Fire
Fighting
Procedures
Material will not burn unless preheated. Do not enter confined fire space without full bunker gear
(helmet/face shield, bunker coat, gloves & rubber boots). Use positive pressure NIOSH-approved
self-contained breathing apparatus. Cool fire-exposed containers with water.
Hazardous
Products of
Combustion
Carbon monoxide, aldehydes, acids & other organic substances may be formed during
combustion (>500F) temperature degradation.
Unusual
Fire/Explosion
Hazards
Heating of resin above 300F in the presence of air may cause slow oxidative decomposition.
Above 500F, polymerization may occur. Some curing agents, e.g. aliphatic amines can produce
exothermic reactions, which in large masses can cause runaway polymerization & charring of
reactants. DO NOT BREATHE FUMES. Unidentified fumes & vapors may be toxic.
Product ID
Quick Setting Gel Epoxy– resin, 15213
CHEMICAL NAME
CAS #
OSHA PEL
ACGIH TLV
Other Limits
Wt. %
Epoxy resin
25068-38-6
NE
NE
NE
60-100
US & CANADA: (800) 424-9300 Int’l & Wash. DC: (703) 527-3887
MATERIAL SAFETY
DATA SHEET