Instruction Manual

WARNING: To reduce the risk of
personal injury from fire and
explosion, do not use the chain saw in the
presence of flammable liquids or gases.
The sparks from an electric chain saw
may be a source of ignition!
WARNING: Inspect the battery
before and after each use for signs
of damage or aging. In order to reduce the
risk of serious injury from electrocution,
never use your chain saw if the battery,
cracked, worn or damaged.
WARNING: To reduce the risk of
personal injury from fire and
explosion, do not use the chain saw in the
presence of flammable liquids or gases.
The sparks from an electric chain saw
may be a source of ignition!
Holding and Controlling the SuperSaw
Always hold the chain saw firmly when
you are working.
Left-handers should follow these
instructions too. Wrap your fingers tightly
around the handles, keeping the handles
cradled between your thumb and
forefinger. With your hands in this position,
you can best oppose and absorb the push,
pull and kickback forces of your saw
without losing control.
WARNING: To reduce the risk of
cut injuries, keep hands and feet
away from the cutting tool. Never touch a
moving cutting tool with your hand or any
other part of your body.
WARNING: Keep proper footing
and balance at all times. Special
care must be taken in slippery conditions
(wet ground, snow) and in difficult,
overgrown terrain. Be extremely cautious
thereafter at regular intervals (whenever
the saw is shut off). If the saw chain
becomes loose while cutting, switch off the
motor, disconnect the chain saw from the
power supply and then tighten. Never try to
adjust the saw chain while the battery is
connected!
WARNING: After adjusting a saw
chain, start the chain saw, let it run
for a while, then switch motor off and
recheck saw chain tension. Proper saw
chain tension is very important at all times.
Keep the handles clean and dry at all times;
it is particularly important to keep them free
of moisture, pitch, oil, grease or resin in
order for you to maintain a firm grip and
properly control your chain saw.
WARNING: Be sure that the guide
bar and saw chain are clear of you
and all other obstructions and objects,
including the ground. If the upper quadrant
of the tip of the bar touches any object, it
may cause kickback to occur. Never
attempt to engage the chain saw when the
guide bar is in a cut.
Electric Precautions
Special precautions for electric chain saws
must be observed to reduce the risk of
personal injury and property damage from
fire and electric shock.
WARNING: To reduce risk of serious
or fatal injury from electrocution,
never use your chain saw if casing around
motor is cracked or damaged.
WARNING: To reduce the risk of &
electrocution never work in rain or
wet places — the electric motor is not
waterproof! Do not leave the chain saw
outdoors in the rain and do not operate it if
it shows any signs of dampness.
SUPERSAW
TM