Install Instructions

Table Of Contents

SEALED UNIT PARTS CO., INC. WWW.SUPCO.COM

P.O. Box 21, 2230 Landmark Place

Allenwood, N.J. 08720 USA

Installation Instructions for

RIM10093 replacement for

WR30X10093

Warning – Disconnect electric power to avoid electrical shock

personal injury or death. This service should be performed by a

qualified service technician.

This kit is designed to replace multiple

styles of ice makers. The kit includes

different fill cups and wire harness. Read

instructions to determine your installation.

For side-by-side refrigerators with porcelain interior without ice

dispenser.

1. Loosen (do not remove) the mounting screws holding the mounting tabs.

2. Slide the old ice maker upwards and pull the ice maker away from the freezer wall.

3. Unplug the ice maker wire harness located on the rear wall of the freezer and remove the old Ice

maker.

4. Determine the position of the fill cup on the old ice maker. If a matching fill cup is included install the

new fill cup into the same position on the new Ice maker. If the fill cup does not match use the fill cup

from the old Ice maker.

5. Match the appropriate wire harness to the connector block on freezer wall. Plug the harness into the

ice maker.

6. Plug the other end of the harness into the freezer wall socket.

7. Lift the ice maker into the screw, making sure the fill spout is aligned with the fill cup. Make sure ice

maker it level. Tighten the screws.

Press release tab to

remove fill cup

Mounting Brackets

PAGE 1
Installation Instructions for RIM10093 replacement for WR30X10093 Warning – Disconnect electric power to avoid electrical shock personal injury or death. This service should be performed by a qualified service technician. This kit is designed to replace multiple styles of ice makers. The kit includes different fill cups and wire harness. Read instructions to determine your installation. For side-by-side refrigerators with porcelain interior without ice dispenser. 1.
PAGE 2
For side-by-side refrigerators with porcelain interior and through the door ice dispenser. 1. Unscrew the front mounting screw and Front mounting screw location 2. 3. pull the Ice maker toward you. Locate the wire harness connector in the back of the freezer. Squeeze the restraints and unplug the harness. Determine the position of the fill cup on the old ice maker. If a matching fill cup is included install the new fill cup into the same position on the new Ice maker.
PAGE 3
For top mount refrigerators 1. Loosen (do not remove) the mounting screws holding the mounting tabs. 2. Slide the old ice maker upwards and pull the ice maker away from the freezer wall. 3. Unplug the ice maker wire harness located on the rear wall or side wall of the freezer and remove the old Ice maker. 4. Determine the position of the fill cup on the old ice maker. If a matching fill cup is included install the new fill cup into the same position on the new Ice maker.