User Manual

Harness User’s manual
SUP’AIR _EVEREST3_Page 11
LIGHT 2B speed-bar/accelerator.
Speed-bar assembly
>> Compatible accelerator/speed-bar
Ref..: ACCELSOUPLELIGHT
>> Speed-bar assembly
Regarding either side of the harness:
1. Push the speed-bar line through the grommet located at the
front of the seat.
2. Push the speed-bar line through the grommet located on the
lateral skirt of the harness.
3. Finally, attach a cimped hook to the cord before connecting it to
the glider’s speed-bar/accelerator.
4. Simulate the speed-bar/accelerator’s functionality by sliding the
cord back and forth.
1
2
1
2
Connect it to the wing using the split hooks.
Once the accelerator/speedbar is connected adjust its length
according to the wing recommended measurements.
For correct use, there must not be any line tension at the split hook
level when the accelerator/speedbar line is fully relaxed.
>> Installing the accelerator.